Converter 4-20mA to 0-10V VIN 7-36V

In the process of circuit signal transmission, the voltage signal will increase with the transmission distance becomes weak, the use of current transmission can avoid the signal weakening. This module is used for the end of the current signal transmission, the signal into a voltage signal for single-chip detection. Current input supports 4-20Ma, 0-20mA, voltage output supports 0-3.3V 0-5V 0-10V. The board is configured for the desired output voltage range by jumpers.

Quick Spec

Power Supply: DC 7~36V (if the output needs to be 10V, the input must be over 12V)

Reverse Polarity Protection

When the current input is at minimum (0mA or 4mA), adjust the Zero potentiometer to make the voltage output to be the minimum value (0.0V or others)

When the current input is at maximum (20mA), adjust the Span potentiometer to make the voltage output to be the maximum value (3.3V or 5V or 10V; the output can be as low as 2.5V when the current input is within 4 -20mA)

Please Note: After power on, the D2 indicator should be on. Otherwise, please check the wiring